Water vapour permeability testing

27th November 2017
Posted By : Peter Smith
Water vapour permeability testing

One reason for faults in electronic products is water vapour which can all too easily permeate into any enclosure, casing, fibre or component - once inside it condenses and causes problems. One solution is from Versaperm which can measure the vapour permeability of both complete products and components or material samples.

The Versaperm system was purpose designed for vapour permeability testing and gives results that are typically accurate in the parts per million (PPM) range and sometimes into PPB. It can measure multiple components, material samples, seals or enclosures at a time.   Environmental conditions can be controlled including temperature, pressure, partial pressure and humidity.

The system can also work with virtually any gas or vapour including water vapour, hydrocarbons, solvents, and CO2.

Versaperm also offers a laboratory service for companies that only need to test samples on an irregular basis.


You must be logged in to comment

Write a comment

No comments




Sign up to view our publications

Sign up

Sign up to view our downloads

Sign up

Imagineering Fair at Bath & West Show
30th May 2018
United Kingdom The Royal Bath & West Society Showground, Somerset
PCIM 2018
5th June 2018
Germany Nuremberg
Developing secure and scalable IoT solutions
21st June 2018
United Kingdom Cocoon Networks, London
SENSOR+TEST 2018
26th June 2018
Germany Nürnberg Exhibition Centre
European Microwave Week 2018
23rd September 2018
Spain Ifema Feria De Madrid